53.11 - upper level perimeter straight bracing connector

Overview

See 3D overview of 53.11

Assembled view

Assembled 53.11

Exploded view

Exploded-view of 53.11

Parts

See order of use for 53.11 - upper level perimeter straight bracing connector

Assembly steps

Prerequisites

1. fL2 or higher is installed
2. central connector is installed
3. sandwich panels are installed

Initial position state of 53.11

Step 1

Insert 2 pcs. of 1.5 plywood washer into sandwich panel holes.

Step 2

Position 3.4 spacer as depicted on the picture above.

Step 3

Position 2 pcs. of 10.15 floor plate with countersunk holes just as depicted in the picture above.

Step 4

Fasten floor plates with 8 pcs. of 99.73 countersunk screw in designated holes for countersunk screws.

Step 5

Fasten floor plate with 2 pcs. of 99.91035 screw.

Note: do not tighten the screws before Step 8

Step 6

Position 15.40 bracing bracket as depicted on the image.

Step 7

Position 2 pcs. of 99.91001 washer onto the holes on the bracing bracket. Screw in 2 pcs. of 99.29 screw.

Step 8

Position 15.40 bracing bracket Bracket for bracing, edge (sheet metal) on the bottom of the connector as depicted on the image. Fasten with 2 pcs. of 99.91008 hex nut.